Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Murray, UT

Screw Drive Opener Repair in Murray, UT

Screw-drive openers cleaned, lubricated and repaired. Typical cost $125-$350.

Garage doors rarely fail at a convenient time. If you need screw drive opener repair in Murray, UT, we can often come out the same day when a technician is available. Screw-drive openers cleaned, lubricated and repaired.

Is it time for screw drive opener repair?

  • The motor runs but the door doesn't move
  • Squealing from the rail
  • Slow or jerky travel, especially in cold weather

What usually causes it

  • Worn trolley or coupler
  • Dry or dirty screw rail
  • Temperature swings affecting the rail

Before the technician arrives

  • Look for grime and dried grease along the threaded rod.
  • Only use the lubricant the manufacturer recommends for the screw rail.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle screw drive opener repair

  1. Inspect the screw, trolley and motor coupler
  2. Clean and lubricate the rail
  3. Replace worn trolley or coupler parts
  4. Set the limits and force
  5. Test the opener

Screw Drive Opener Repair cost in Murray, UT

$125-$350Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Drive type: chain, belt, screw or wall-mount
  • Whether the fix is a part or a whole new opener
  • Remotes, keypads and smart accessories
  • Ceiling height and rail extensions

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Screw Drive Opener Repair in Murray, UT

Rapid temperature changes in Utah can throw off opener travel limits, and cold mornings make a weak opener struggle with a door that is out of balance.

Our screw drive opener repair service covers Murray (ZIP codes 84090, 84091 and 84107) and nearby towns including Millcreek (1.5 mi), Taylorsville (2.7 mi), Holladay (3.3 mi) and South Salt Lake (3.6 mi). Call (833) 435-8883 to book a visit in Murray.

Screw Drive Opener Repair: frequently asked questions

How much does screw drive opener repair cost in Murray, UT?

Screw Drive Opener Repair typically costs $125-$350 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do screw drive opener repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is screw drive opener repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Utah or Murray requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my opener?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the opener is near the end of its life, replace it. Most openers last 10 to 15 years. If yours is older than that, lacks photo eyes or rolling-code security, or needs a logic board or motor, a new opener is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Murray, UT

Steel Garage Door Repair

Dents, rust and bent sections on steel doors repaired or replaced.

Typical $150-$600

Garage Door Replacement

Old or damaged doors replaced with a new door, springs, tracks and hardware.

Typical $1,200-$5,000

Garaga Garage Door Repair

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $150-$450

Overhead Door Rolling Fire Door Inspection & Drop Testing

Annual drop testing and inspection of rolling fire doors.

Typical $150-$500

Haas Door Rolling Steel Door Repair

Rolling steel service doors, curtains, guides and springs repaired.

Typical $300-$1,500

Martin Door Garage Door Track Repair

Bent, loose or misaligned tracks straightened, realigned or replaced.

Typical $150-$400

Raynor Torsion Spring Replacement

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $200-$450

Overhead Door Weather Seal Replacement

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $100-$300

Amarr Garage Door Roller Replacement

Amarr, an ASSA ABLOY Group brand, makes residential lines such as Classica, Heritage, Lucern and Oak Summit, as well as commercial doors.

Typical $150-$350

Opener Circuit Board Replacement

Failed logic boards and receivers replaced, often after a power surge.

Typical $175-$400

Rytec High-Speed Door Repair

Rytec specializes in high-speed doors for warehouses, manufacturing and cold storage.

Typical $400-$2,000

Richards-Wilcox Garage Door Installation

New steel, insulated, wood-look and carriage-style doors, measured and professionally installed.

Typical $1,200-$4,500

Garage door stuck, noisy or broken?

Talk to a garage door technician in Murray, UT now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote